Factors Affecting Implant Stability Quotients at Immediately and Conventionally Loaded Implants in the Posterior Maxilla: A Split-Mouth Randomized Controlled Trial.

PURPOSE: To assess primary and secondary stability of variable-thread tapered implants in the posterior maxilla and analyze the impact of various factors on implant stability quotients (ISQs). MATERIALS AND METHODS: Twenty-six subjects received 3-4 adjacent implants in the maxillary premolar-molar sextants to replace bilateral tooth loss. The implants on one side were immediately loaded with a provisional fixed prosthesis regardless of their primary stability. The contralateral control implants were conventionally loaded. Bone quality was subjectively recorded and primary stability was assessed by means of insertion torque values (ITVs) and ISQs in 4 directions. Secondary stability was measured by ISQ at definitive prosthesis delivery (3-3.5 months postoperatively), and 12 months after definitive loading. The impact of measurement direction, loading protocol, time, site-related (bone quality, implant position, crestal buccal bone thickness, apical cortical anchorage), and implant-related (implant dimensions, abutment height) variables on ISQs was assessed. RESULTS: For logistic reasons, ISQs were obtained for only 18 patients with 60 test and 60 control implants. Most of the implants (82%) at baseline had their lowest ISQ on the buccal aspect. There were no significant differences between ISQs measured in the buccal and palatal directions, or between ISQs in the mesial and distal directions. The mean of buccal and palatal ISQs was significantly lower than the mean of the 2 interproximal measurements at all evaluation periods. ISQs were not significantly different between the 2 loading groups at any time point. All implants showed a time-dependent increase in ISQs. Baseline ISQ correlated weakly with bone quality and ITV. None of the variables had a significant impact on baseline ISQs, except for implants in second molar sites which showed poorer primary stability than first premolars. CONCLUSION: Measurement direction and time are the most significant parameters affecting ISQs of variable-thread tapered implants in the posterior maxilla.

Immediate versus conventional loading of variable-thread tapered implants supporting three- to four-unit fixed partial dentures in the posterior maxilla: 3-year results of a split-mouth randomised controlled trial.

PURPOSE: To compare the 3-year outcomes of immediately loaded and one-stage conventionally loaded variable-thread tapered implants in the posterior maxilla. MATERIALS AND METHODS: This study was designed as a split-mouth randomised controlled trial. Twenty-six patients attending the postgraduate Periodontics Department at the Lebanese University, and missing teeth bilaterally in the posterior maxilla were randomised. All patients received three to four implants in each of the posterior sextants. The implants on one side were immediately loaded with a provisional resin fixed partial denture on definitive multi-unit abutments regardless of their primary stability. The implants in the contralateral side received definitive multi-unit abutments according to the one-stage unloaded protocol. Three to 3.5 months following implant placement, the implants were restored with metal-ceramic fixed prostheses. Outcome measures were implant and prosthesis failure rates, complications, and peri-implant bone level changes up to 3 years following delivery of the definitive prosthesis. The clinical outcomes and radiographic measurements were performed by a single outcome assessor blinded to the type of interventions. RESULTS: Two patients dropped out prior to the delivery of definitive prostheses. The results were analysed using a per-protocol analysis and included 24 patients. Four implants supporting a four-unit immediately loaded prosthesis failed in one patient, 3 months following definitive prosthesis. In the same patient, the three contralateral conventionally loaded implants failed 14 months after definitive prosthesis. There were no significant differences in the proportions of implant and prosthesis failures at 3 years (difference = 0%; 95% CI 0.0% to 14.2%; P = 0.999). Peri-implantitis was diagnosed at two adjacent conventionally loaded implants in one patient at the 3-year examination. In the immediately loaded group, four early minor prosthetic complications occurred during the provisionalisation phase. Following delivery of the definitive prostheses, one minor ceramic fracture was observed in each of the implant groups. The difference in the rate of complications between the two interventions was not statistically significant at 3 years (difference = 13%; 95% CI 3.4% to 27.7%; P = 0.453). The 3-year peri-implant marginal bone level changes were evaluated in 23 patients (77 immediately loaded and 76 conventionally loaded implants). On average, patients lost 0.79 (0.62) mm at the immediately loaded and 0.91 (0.82) mm at the conventionally loaded implants, the difference being statistically not significant (difference = 0.12 mm; 95% CI -0.31 to 0.55 mm; P = 0.590). The 3-year marginal bone level changes were not significantly different between smokers (n = 12) and non-smokers (n = 11) (difference = 0.19 mm; 95% CI -0.24 to 0.62 mm; P = 0.382). CONCLUSIONS: Immediate loading of three- to four-unit fixed partial prostheses supported by variable-thread implants in the posterior maxilla can achieve similar 3-year results to one-stage conventionally loaded implants.

Insertion Torque of Variable-Thread Tapered Implants in the Posterior Maxilla: A Clinical Study.

PURPOSE: Primary stability is a key factor for successful implant osseointegration, especially in poor bone quality and early/immediate loading. In the immediate loading protocol, insertion torque values (ITVs) have been suggested to be the most valid prognostic factor for osseointegration of maxillary implants. The objectives of this study were to: (1) evaluate ITVs achieved by a variable-thread tapered implant in the posterior maxilla; and (2) assess the impact of bone quality, implant dimensions, bicortical anchorage, and implant location on ITVs. MATERIALS AND METHODS: Twenty-six adult, systemically healthy patients received 173 variable-thread tapered implants in maxillary premolar and molar healed edentulous sites with a minimum subsinus height of 8 mm. Implant sites were prepared using the bone-quality adjusted drilling sequence according to manufacturer's recommendations. Bone quality was recorded subjectively during drilling based on Misch criteria (D1-D4), and ITVs were measured with a manual torque wrench. Univariate and multivariate analyses were performed at the 0.05 significance level. RESULTS: First and second molar sites accounted for 46.8% of all implants. D4 bone was encountered in 61.3% of the sites. Most of the implants were 4.3 mm in diameter (59.5%), and lengths of 11.5 and 13 mm were most commonly used (75.2%). Approximately half of the implants were associated with apical cortical anchorage (51.4%). The overall mean ITV was 44.5 ± 23.0 Ncm, with 65.5 ± 15.6 Ncm, 55.5 ± 19.6 Ncm, and 36.6 ± 21.7 Ncm for D2, D3, and D4 bone, respectively. Bone quality and implant location significantly affected ITVs, while implant dimensions and apical cortical anchorage did not. CONCLUSIONS: ITVs of variable-thread implants were significantly influenced by variations in bone quality and implant position in the posterior maxilla. Despite the influence of bone quality on primary stability, the mean ITVs attained with variable-thread tapered implants in poor bone quality were within the recommended range for immediate loading.

Immediate vs conventional loading of variable-thread tapered implants supporting three- to four-unit fixed partial dentures in the posterior maxilla: 1-year interim results of a split-mouth randomised controlled trial.

PURPOSE: To compare the outcome of immediately loaded and one-stage conventionally loaded variable-thread tapered implants in the posterior maxilla. MATERIALS AND METHODS: This study was designed as a split-mouth randomised controlled trial. Twenty-six patients missing teeth bilaterally in the posterior maxilla received three to four implants in each of the posterior sextants. Bone quality was recorded based on Misch criteria (D1-D4) and insertion torque values were measured using a manual wrench. The implants on one side were immediately loaded with a temporary resin fixed partial denture on definitive multi-unit abutments. The implants in the contralateral side received definitive multi-unit abutments according to the one-stage unloaded protocol. Three to 3.5 months following implant placement, the implants were restored with metal-ceramic fixed prostheses. Outcome measures were implant and prosthesis failure rates, complications, and peri-implant bone level changes at 1 year following delivery of the definitive prostheses. RESULTS: Two patients dropped out prior to the delivery of definitive prostheses. Four implants supporting a four-unit immediately loaded prosthesis failed in one patient, 3 months following delivery of the definitive prostheses. None of the conventionally loaded implants or prostheses failed. There were no significant differences in the proportions of implant and prosthesis failures (difference = 4.2%; 95% CI -4.2 to 12.6%; P = 0.999). In the immediately loaded group, four early prosthetic complications occurred during the provisionalization phase (three small resin chippings and one prosthetic screw loosening). No other complications were reported. The difference in the rate of complications between the two interventions was not statistically significant (difference = 16.7%; 95% CI -1.2% to 35.6%; P = 0.125). The 1-year peri-implant marginal bone level changes were evaluated in 23 patients (77 immediately loaded and 76 conventionally loaded implants). On average, patients lost 0.42 mm at the immediately loaded and 0.46 mm at the conventionally loaded implants, the difference being statistically not significant (difference = 0.044 mm; 95% CI -0.27 to 0.18 mm; P = 0.701). CONCLUSIONS: Immediate loading of 3- to 4-unit fixed partial prostheses supported by variable-thread implants in the posterior maxilla can yield good and similar 1-year results to one-stage conventionally loaded implants.